Tweco Victor Torch Handles,Cutting Attachments Manual de usuario descargar pdf (Pagina 20)

6-16

delivery gauge rises, there is a leak in the regulator seat. Take the

regulator to a qualiﬁed repair technician for repair.

7. After leak testing the system, open the cylinder valves and

proceed.

WARNING

If a leak has been detected anywhere in the system, discontinue

use and have the system repaired. DO NOT use leaking equipment.

Do not attempt to repair a leaking system while the system is under

pressure. Perform all operations in a well-ventilated area to help

prevent the concentration of ﬂammable or toxic fumes.

SECTION 6:

WELDING NOZZLES

1. Inspect the cone end, coupling nut, O-rings, and welding nozzle

for damage, oil or grease. Do not use if damage or contaminants

are present.

WARNING

There must always be two O-rings on the cone end. The absence or

damage of either of these O-rings allows premixing of the oxygen

and fuel gases. This can lead to a sustained backﬁre within the

torch handle.

2. Connect the welding nozzle to the torch handle. Tighten the coupling

nut HAND TIGHT only. Using a wrench could damage the O-rings

and create a faulty seal.

MULTI-FLAME HEATING NOZZLES (ROSEBUDS)

Multi-ﬂame heating nozzles are set up exactly as the welding nozzle.

Follow the safety and operation procedures described above for the

welding nozzle.

CAUTION

Never starve or choke a welding nozzle or multi-ﬂame heating

nozzle. This causes overheating of the nozzle and a backﬁre or

sustained backﬁre may result. Should a sustained backﬁre occur

(ﬂame pops and disappears and/or a hissing sound is heard, the

ﬂame is burning inside the nozzle), immediately turn off the oxygen

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 93 94

Sin comentarios

Tweco Victor Torch Handles,Cutting Attachments Manual de usuario Pagina 20