
Quick ROBOtics light weight tORch
4-9
SM-QRLTORCH
WIRING
SECTION 4:
WIRING
Connection Part No. Stock No.
Without Connector QRJC-010 3045-1241
Burndy (ABB) QRJC-020 3045-1242
4-pin Amp (Motoman) QRJC-030 3045-1243
5-pin DDK (Fanuc) QRJC-040 3045-1244
Table 2: E-Stop Adapter Jumper Cables
CONTROL CABLE ASSEMBLY - (QRLXX-CC-F)
E-STOP ASSEMBLY - (QRL-RH-F)
The QRL torch is furnished with a receptacle housing mounted
on the front case. The 3-pin socket receptacle will accept
the RDML-2000-JC E-Stop Jumper Cable from the robot
deflection mount.
The receptacle is connected to a 3-wire cable that runs along
the inside of the inner protective jacket. The end of this cable
extends approximately 1ft. (.3m) out of the rear case and
comes standard with a 9-pin amp plug. Adapter jumper cables
are available to connect this cable to most robots (Table 2).
Wiring Schematic for E-Stop Cable
Comentarios a estos manuales